In order to improve the monitoring sensitivity when installing the ladle toaster, the controller cable should be careful to prevent mixing with other power plugs or power cables. The following common problems must be mastered:

1. If the camera is far away from the monitor and the contact resistance of the pantograph is large, it can ignite without flame. Please turn on the module and slowly adjust the resistor in the middle of the module in the opposite direction until the red indicator is off and the relay is released. At this point, the module adjustment is over and the module cover has been closed

2. Do not overshoot when adjusting the baker because overshoot will harm the monitoring sensitivity

3. After the installation of the baker and proper wiring, the switch power can be turned on and the switch power indicator light is lit. The control panel of the control cabinet is equipped with a power switch for operation. Turn the power switch to the working attitude, and the operation indicator light is on

4. When there is a flame data signal, the ignition indicator light is on; When there is no flame data signal, the fire indicator will go out and send out a light control alarm