According to Fuxingda Environmental Protection Equipment Co., Ltd.'s many years of on-site practical operation and after-sale maintenance experience on the failure of the baker, the reasons for the failure of the baker include the following factors:

1. There is a problem with the power control circuit of the baker, and the circuit connection is loose or damaged

2. The transformer is faulty and cannot be ignited normally. Sometimes, it will produce explosion

3. The electrode in charge of the ignition of the baker is not installed correctly or the ignition electrode is deformed, so it cannot be ignited normally

4. Problems in the flame monitoring system, such as being covered by water vapor, loosening of the monitoring circuit or failure of the ultraviolet tube to monitor the flame normally, will lead to faults

5. When the control button of the burner controller is pressed, the signal cannot be sent to the burner, that is, the controller fails

6. There is a problem with the gas pipeline. After resetting, the pneumatic valve of the gas does not move, the manual flow regulating valve is locked or the manual ball valve fails to ignite

7. There is an error in the gap of the gas pneumatic valve, which makes the gas valve unable to open and close normally, or even the gas leakage causes failure to use normally

8. There is a problem with the distributor of the pneumatic valve. The solenoid coil of the air-guided valve is burnt out and cannot work

9. The solenoid switch rectifier of the air solenoid valve is burnt out

10. There is a problem with the controller control program of the baker

Fuxingda baker

In addition, the damage of the ceramic inner tube of the burner chamber, the low pressure of the gas and too many impurities will affect the normal operation of the burner